Need help?Do you have a question about the Makita HS0600 and is the answer not in the manual?
General| Input power | 2100 W |
|---|---|
| Cable length | 2.5 m |
| Power source | AC |
| Diamond disc bore size | 25.4 mm |
| Blade diameter | 270 mm |
| Idle speed (max) | 4300 RPM |
| Cutting depth (45º) | 71 mm |
| Cutting depth (90º) | 101 mm |
| Sound pressure level | 94 dB |
Weight and Dimensions| Depth | 418 mm |
|---|---|
| Width | 273 mm |
| Height | 324 mm |
| Weight | 6900 g |
Read all safety warnings, instructions, illustrations, and specifications provided with this power tool.
Keep work area clean and well lit. Avoid explosive atmospheres. Keep children and bystanders away.
Match plugs to outlets. Avoid body contact with earthed surfaces. Protect from rain or wet conditions.
Stay alert, use PPE, prevent unintentional starting, remove adjusting keys, do not overreach.
Do not force the tool, ensure switch works, disconnect power, store properly, maintain tools.
Keep hands away from blade, do not reach underneath, adjust cutting depth, secure workpiece.
Align 0° position for straight cuts, 45° for bevel cuts. Never hold workpiece in hands.
Understand kickback, maintain firm grip, release trigger when binding, restart carefully.
Check lower guard operation, never clamp it open, ensure it moves freely.
Use caution with damp wood, avoid cutting nails, support workpieces.
Loosen lever, move base, tighten lever securely for cleaner cuts.
Loosen lever and screw, set angle, tighten securely.
Align 0° or 45° position on base with cutting line.
Check trigger function, use lock button for continuous operation.
Press shaft lock, loosen hex bolt counterclockwise, remove parts.
Clean upper and lower guards of sawdust, check operation.
Store hex wrench when not in use to prevent loss.
Connect dust nozzle and vacuum cleaner hose for clean cutting.
Slide rip fence snugly against workpiece for accurate straight cuts.
Adjust base parallelism by loosening screws and moving rear of base.
Adjust base perpendicularity using a square rule and adjusting screw.
Check and replace carbon brushes when worn to the limit mark.
To Next Page
