To Next PageTo Next Page
Need help?Do you have a question about the Makita HTR5600 and is the answer not in the manual?
General| Engine Type | 2-stroke |
|---|---|
| Cutting Width | Not applicable |
| Weight | 5.2 kg |
| Blade Length | 560 mm |
| Blade Type | Double-sided |
| Power Source | Petrol |
| Fuel Tank Capacity | 0.4 L |
| Handle Type | Loop handle |
| Power Output | 0.83 kW |
| Engine Displacement | 22.2 mL |
User must read and understand the manual for correct operation and safety.
Mandatory use of safety goggles, hearing protection, gloves, and proper clothing.
Handle fuel with care, stop engine, keep away from flames, use correct mixture.
Keep hands away from blades to prevent severe injury. Blade may coast after stopping.
Always stop engine before servicing, clean regularly, check screws, store safely.
Use correct gasoline and MAKITA 2-stroke oil mixture (50:1) for engine life and environment.
Handle fuel with care, avoid skin contact and vapor inhalation, protect eyes.
Stop engine, clean cap, fill tank carefully, screw cap tightly, wipe up spills.
Store fuel in approved containers for limited periods, away from children.
Restarting a hot engine may require specific procedure, refer to steps 1, 7, 8 or 1-11.
If blades hit stones, switch off engine immediately and inspect for damage.
Grind off shaded portions of rounded edges, securing blade firmly before sharpening.
Adjust blades by screwing in nut lightly until tight, then lubricate and test engine.
