Makita LC06ZW - Reassembly Procedures

7
2
1
► 1. Filter 2.Prelter
Reassembly
Putonthelterfullyinpositiononthecleanerunit.
1
► 1. Filter
NOTICE: Make sure the lter is put on straight
without being peeled back.Ifthelterisputon
incorrectly as illustrated, dust will get into the motor
housing, and cause a motor failure.
1
► 1. Filter
Install
theprelter.Atthistime,makesuretotwistthe
preltersothatthesecuringlipisrmlylockedinthe
cleaner unit.
2
1
► 1.Prelter2. Securing lip
Installthecapsule.Alignthemarkonthecapsulewith
themarknearthehandleandthenrmlytwistthecap-
sule in direction of the arrow until it is secured.
3
2
1
► 1. Capsule 2. Handle 3. Mark
NOTE: Always remove dust ahead of time, as the
suction power will be reduced if there is too much
dust in the cleaner.
NOTICE: Always be sure to check that both the
lter and prelter are loaded correctly prior to
using the cleaner.Iftheyarenotloadedcorrectly,
dust will get into the motor housing, and cause a
motorfailure.Ifthefollowingexamplesoccur,thelter
andprelterarenotloadedcorrectly.Reloadthem
correctly to rectify problem.