Makita TD111DSAJ User Manual

9 ENGLISH
OPERATION
Theproperfasteningtorquemaydifferdependingupon
thekindorsizeofthescrew/bolt,thematerialofthe
workpiecetobefastened,etc.Therelationbetweenfas-
teningtorqueandfasteningtimeisshowninthegures.
Standard bolt
N•m
(kgf•cm)
2
1
2.01.
03
.00
100
(1,020)
120
(1,224)
80
(816)
60
(612)
40
(408)
20
(204)
M12
M14
M10
M12
M14
M10
M8
M8
3
1. Fastening time (second) 2.Fasteningtorque
3.Properfasteningtorquecorrespondingtoeachbolt
diameter
High tensile bolt
32
1
N•m
(kgf•cm)
2.01.00
80
(816)
60
(612)
40
(408)
20
(204)
3.0
100
(1,020)
120
(1,224)
M10
M12
M12
M8
M8
M10
1. Fastening time (second) 2.Fasteningtorque
3.Properfasteningtorquecorrespondingtoeachbolt
diameter
Holdthetoolrmlyandplacethepointofthedriverbit
inthescrewhead.Applyforwardpressuretothetoolto
the extent that the bit will not slip off the screw and turn
the tool on to start operation.
NOTICE: If you use a spare battery to continue
the operation, rest the tool at least 15 min.
NOTE:Usetheproperbitfortheheadofthescrew/
bolt that you wish to use.
NOTE:WhenfasteningM8orsmallerscrew,choose
aproperimpactforceandcarefullyadjustpressureon
the switch trigger so that the screw is not damaged.
NOTE: Hold the tool pointed straight at the screw.
NOTE: If the impact force is too strong or you tighten
thescrewforatimelongerthanshowninthegures,
the screw or the point of the driver bit may be over-
stressed, stripped, damaged, etc. Before starting your
job,alwaysperformatestoperationtodeterminethe
proper fastening time for your screw.
Thefasteningtorqueisaffectedbyawidevarietyof
factorsincludingthefollowing.Afterfastening,always
checkthetorquewithatorquewrench.
1. Whenthebatterycartridgeisdischargedalmost
completely, voltage will drop and the fastening
torquewillbereduced.
2. Driver bit or socket bit
Failure to use the correct size driver bit or socket
bitwillcauseareductioninthefasteningtorque.
3. Bolt
• Eventhoughthetorquecoefcientandthe
class of bolt are the same, the proper fasten-
ingtorquewilldifferaccordingtothediame-
ter of bolt.

Makita TD111DSAJ Specifications

General

Brand	Makita
Model	TD111DSAJ
Category	Impact Driver
Language	English