Why does my Makita Ultrasonic Jewelry Cleaner have weak suction power?
The weak suction power in your Makita Ultrasonic Jewelry Cleaner may be due to several reasons: * The capsule might be full of dust, in which case you should empty it. * The filter could be clogged; try cleaning or washing it. * The battery cartridge may be exhausted. If so, charge the battery cartridge.
General| Voltage | 10.8V |
|---|---|
| Max Torque | 110 Nm |
| No Load Speed | 0-2, 600 RPM |
| Impacts Per Minute | 0 - 3, 200 ipm |
| Battery Type | Li-ion |
| Driving Shank | 1/4" Hex |
| Machine Screw | M4-M8 |
| Standard Bolt | M5-M12 |
| High Strength Bolt | M5-M10 |
| Coarse thread screw (length) | 22-90 mm |
| Weight with battery | 1.2 kg |
| Length | 153 mm |
| Blows Per Minute | 0 - 3, 200 ipm |
Highlights essential safety precautions for operating the cordless cleaner.
Provides crucial safety information regarding battery cartridge handling and care.
Step-by-step guide for attaching and detaching the battery pack.
Explains the tool's system that protects the battery from overload and low voltage.
Instructions for removing dust collected by the normal filter.
Instructions for removing dust collected by the high performance filter.
Steps for correctly reassembling the normal filter into the cleaner.
Provides solutions for typical operational problems encountered with the cleaner.
To Next Page
