Makita UH7580 - Shear Blade Replacement; Removing the Shear Blades; Installing the Shear Blade

10 ENGLISH
Remove the under cover.
1
2
►1. Under cover 2. Blade cover
Remove the gear housing cover.
1
►1. Gear housing cover
Setthecrankattheangleasshowninthegurewitha
slotted bit screwdriver.
1
►1. Crank
Remove two screws from the shear blades and the
shear blade unit will be taken out.
1
2
►1. Screws 2. Shear blade
CAUTION:
• Return the gear to the original position in such
a manner as it was installed if it should be taken
away by mistake.
Installing the shear blade
Prepare 4 removed screws (For under cover), 2 screws (For shear
blade), gear housing cover, under cover, and new shear blades.
Adjustthecrankpositionasshowninthegure.At
this time, apply some grease provided with new shear
blades to the periphery of the crank.
1
►1. Crank
Overlap the oval hole in the upper blade with that in the
lower one.
1
►1. Ellipse of shear blade