How to fix a Makita Vacuum Cleaner when the motor does not start?
If your Makita Vacuum Cleaner's motor doesn't start, first check the fuse in the mains plug and reset it if it has blown. Also, the overload protection switch might have tripped. If so, switch off the vacuum cleaner and let it cool for about 5 minutes. If it still won't start, further assistance is needed.
Why does my Makita VC3012M Vacuum Cleaner have reduced suction power?
If your Makita Vacuum Cleaner experiences reduced suction power, several factors could be at play. Ensure the suction power control isn't set too low. Also, verify that the hose diameter corresponds with the switch position. A clogged suction hose or nozzle can also cause this, so be sure to clean them. Check the seal or tank rim between the upper section and the dirt tank for dirt or defects, and clean or replace if necessary. Finally, a full filter bag requires replacement, or a clogged filter element needs cleaning or replacement.
What to do if my Makita Vacuum Cleaner has no suction power during wet cleaning?
If there's no suction power during wet cleaning with your Makita Vacuum Cleaner, it's likely that the tank is full, causing the floater to close the suction opening. To resolve this, switch off the cleaner and empty the tank.
Why won't the motor run in automatic mode on my Makita VC3012M?
If the motor of your Makita Vacuum Cleaner does not run in automatic mode, the power tool may be defective or not connected properly. Check that the power tool works or that the plug is inserted correctly.
What causes voltage fluctuations in my Makita VC3012M Vacuum Cleaner?
Voltage fluctuations in your Makita Vacuum Cleaner may occur if the impedance of the power supply is too high. Use a suitable extension cord or connect the cleaner to another socket closer to the fuse box. Voltage fluctuations over 7 % should not occur if the impedance at the transfer point is ? 0.15 ?.
Details the intended applications and limitations of the vacuum cleaner.
Instructions for vacuuming liquids, including filter removal and float checks.
Procedure to restore suction performance by cleaning the filter element.
General| Dust class | M |
|---|---|
| Cleaning type | Dry&wet |
| Product color | Black, Blue, White |
| Filter material | Polyethylene terephthalate (PET) |
| Capacity | 30 L |
| Hose length | 4 m |
| Noise level | 59 dB |
| Cable length | 7.5 m |
| Hose diameter | 32 mm |
| Filter surface | 3000 cm² |
| Number of wheels | 4 wheel(s) |
| Container capacity (dust) | 23.5, 30 L |
| Container capacity (water) | 19 L |
| Ventilating pressure (max) | 230 mbar |
| Input power | 1200 W |
| Flexible hose | Yes |
Weight and Dimensions| Depth | 450 mm |
|---|---|
| Width | 380 mm |
| Height | 595 mm |
| Weight | 10000 g |
To Next Page
