Makita XLC03 - Assembly; Parts Description; Filter and Component Handling; Disposing of Dust

7 ENGLISH
Lighting up the lamp
CAUTION: Do not look in the light or see the
source of light directly.
To turn on the lamp, pull the switch trigger. During the
tool actuating, the lamp turns on.
Release the switch to turn off the lamp.
When the remaining battery capacity gets low, the lamp
starts blinking.
1
2
►1. Lamp 2. Switch trigger
NOTE: The timing, at which the lamp starts blinking,
depends on the temperature at work place and the
battery cartridge conditions.
ASSEMBLY
CAUTION: Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Parts description
Optional accessory
High performance lter and stay and
sponge lter
1
2
3
►1. Capsule 2.Highperformancelter3. Stay and
spongelter
Prelter or high performance lter
and HEPA lter
1
2
4
3
►1. Capsule 2.Prelter3.Highperformancelter
4.HEPAlter
NOTICE: Do not use the high performance lter
with the lter (optional accessory). The high per-
formanceltermaybecomeunremovablefromthe
cleaner.
NOTE:Whenusingtheoptionalprelterandlterwith
theHEPAlter,useonlytheprelterovertheHEPA
lter.IfyouuseprelterandlterwiththeHEPAlter
at the same time, the suction power may be reduced.
NOTE:WhenusingtheHEPAlterwiththehigh
performancelter,usethehighperformancelterwith
the stay.
1
►1. Stay
Disposing of dust
CAUTION: Empty the cleaner before it
becomes too full, or the suction force weakens.
CAUTION: Be sure to empty the inside of the
cleaner itself of dust. Failure to do so may cause the
ltertobecloggedorthemotortobedamaged.
Inordertodropduststickingonthelterinthecapsule,
tap the capsule 4 or 5 times with your hand.