MAKOT MCH-07 Series - Washing Mode Controller Functions; Washing Program Management

Strona 16 z 27
number of programs
8
number of factory (default) programs
4
maximum number of steps in each program
50
minimum duration of one step
1 s.
maximum duration of one step
99 min.
range of the control temperature
[only MCH-07T version]
from 9,0
O
C to 99,0
O
C
resolution of control temperature settings
[only MCH-07T version]
0,5
O
C
length of temperature sensor
[only MCH-07T version]
5 m
number of relay outputs
7
load capacity of the relay contacts
10A 250V AC
number of control inputs
MCH-07 – 1 (hydrostatic)
MCH-07T – 2 (hydrostatic and temperature
sensor)
type of display
LED
power supply
23 V AC 50Hz
4.2. Controller functions in washing mode.
The MCH-07 controller has a number of functions of the washing segment described below.
4.2.1. Washing programs.
Controller’s memory has capacity for 8 programs, with two programs for washing the milking
machines (devices) and two programs for washing the cooling devices pre-programmed.
The remaining 4 spots allow an installer to create programs adapted to the individual needs
of an user.
4.2.2. Modification and creation of programs.
The controller allows to modify factory programs according to the needs of the user.
It is also possible to create programs by yourself (by the installer). Each program can have
a maximum of 50 steps with a duration of 1 sec. to 99 min. The programming method has been
presented in the graphic form in section 4.3.2.
4.2.3. Protection in the event of a power supply failure.