Strona 21 z 27
The controller is equipped with: 4 washing programs (pre-programmed), which can be freely
edited by the installer as required, as well as 4 washing programs to be programmed by the
installer (they are empty as default). Each program can contain up to 50 steps. Each step is
assigned:
− status of all 7 relay outputs,
− hydrostatic input status,
− duration of the step.
When programming or editing an existing program, the following buttons perform the following
functions:
– changing the value of a setting upwards, e.g. function, time, temperature,
– relay activation
– changing the value of a setting downwards, e.g. function, time, temperature
– relay deactivation
– confirmation of entering the parameter
– confirmation of changes made
– exit from the settings after confirming the changes with the S button
– exit from the settings without making changes
ATTENTION
1. When programming the activation of the hydrostatic input (relay 8), it is necessary
to program the maximum allowable time of pouring water. The time parameter is superior
to the hydrostatic signal, providing protection against too much water. Not programming
this parameter will result in the lack of reaction to the hydrostatic signal and at the same
time the lack of pouring water.
2. Before creating a new program or editing an existing program, it is recommended
to create a table as shown in the description of the programs. This will facilitate efficient
programming.
3. In the event of inactivity during programming, the controller automatically exits this
process without saving changed data.
To Next Page
Loading...
