Strona 22 z 27
4.3.3. Return to factory settings.
To return to the default settings, enter the controller settings. Use the ▲ and ▼ buttons
to select the Pd0d, confirm the selection by pressing the S button, then change the value of this
parameter from 0 to 1 using the ▲ button. Then confirm the changes by pressing the S button
again. After doing this, disconnect the power supply from the controller and switch it on again.
ATTENTION
1. Using the procedure described above will remove any settings from the controller's memory
while restoring factory settings. Therefore, be consciously using this option.
2. The return to factory settings takes place only after disconnecting and restarting
the controller's power supply; changing the Pd0d parameter by itself will not return to the
factory settings.
4.3.4. Test mode.
The test mode is used for accelerated checking of the correct operation of the entire washing
system controlled by the controller. Working in the test mode consists in the possibility
of manually going to the next steps of the program (factory, modified factory or own), without
having to wait for the time programmed for a given step to elapse.
To Next Page
Loading...
