Strona 27 z 27
When this button is pressed, the washing program is completely interrupted and deactivated
and the controller goes into the ready status. Restarting the program will cause its execution
from the beginning.
4.4.4. Manual activation of the vacuum pump or the stirrer.
If this function is activated (UPP parameter – see section 4.3.1.), the user has the option
of manually activate the vacuum pump or the stirrer operation (relay 4). Default settings or made
by the installer determine which output (vacuum pump – PP or stirrer – PPR) will be switched
on manually.
Manual switching is only possible when the washing program is not being carried out; while
the program is running, the manual start button is inactive.
The stirrer can also be switched on at any time by pressing the manual work of the stirrer in the
cooling segment, even if the cooling is switched off. In this case, the relay 4 does not need to be
assigned to the stirrer.
To Previous Page
Loading...
