6
blade, resulting in a serious personal injury.
To i ns ta ll the bl a d e, lo os en th e b o lt cou nt er c l oc k w is e o n
the blade holder with the hex wrench.
With the blade teeth facing forward, insert the blade into
the blade holder as far as it will go. Make sure that the
back edge of the blade fits into the roller. Then tighten the
bolt clockwise to secure the blade.
1
2
3
011281
To re m o ve the bl a d e, fo l lo w t h e in s t al la ti o n pr oc ed ur e i n
reverse.
NOTE:
• Occasionally lubricate the roller.
Hex wrench storage
1
2
011282
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
OPERATION
CAUTION:
• Always hold the base flush with the workpiece.
Failure to do so may cause blade breakage,
resulting in a serious injury.
• Advance the tool very slowly when cutting curves or
scrolling. Forcing the tool may cause a slanted
cutting surface and blade breakage.
1
2
011283
Turn the tool on without the blade making any contact
and wait until the blade attains full speed. Then rest the
base flat on the workpiece and gently move the tool
forward along the previously marked cutting line.
Bevel cutting
011284
CAUTION:
• Always be sure that the tool is switched off and
unplugged before tilting the base.
• Raise the dust cover all the way before making
bevel cuts.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
1
2
3
011285
Loosen the bolt on the back of the base with the hex
wrench. Move the base so that the bolt is positioned in
the center of the cross-shaped slot in the base.
1
2
011286
Tilt the base until the desired bevel angle is obtained.
The edge of the motor housing indicates the bevel angle
by graduations. Then tighten the bolt to secure the base.
1. Edge
2. Graduation
1. Hex wrench
2. Bolt
3. Base
1. Cutting line
2. Base
1. Hook
2. Hex wrench
1. Bolt
2. Roller
3. Blade
To Next Page
Loading...
