10
MAINTENANCE AND LUBRICATION
Check, and tighten (if required), all nuts, bolts and fixing after the first few hours of work and at
regular intervals thereafter. Grease PTO shaft every 20 hours of operation and pre / post season.
Good maintenance of a machine will ensure a safe working environment and long service life of the
machine.
• Lubricate the PTO shaft as in the manufacturer’s handbook.
• Grease the pivot joints and the drive line every 8-10 working hours.
• Central Gear box (80-90 gear oil) change oil after 50 working hours for the first time
and then after every 400 working hours.
Periodic attention
An inspection and maintenance check is necessary for the Topper every year. The Topper should be
overhauled from time to time during the year to see if lubrication or maintenance is needed.
Maintenance overhaul consists of:
• Examination of nuts & bolts – tighten them if required.
• Examination of PTO shaft protections cover.
• Lubrication according to the instructions for maintenance and lubrication.
Storage
The machine should be stored on a firm level site in a safe, clean and dry location where it is protected
from the elements. It is advisable that prior to storage of the Topper at the end of the season that the
machine be lubricated thoroughly and the opportunity taken to check the machine for worn or damaged
parts - replacements can then be ordered and fitted so that the machine is ready for the next seasons work.
Operator Manual—Topper
To Next Page
Loading...