23.2 Keep batteries out of the reach of children
23..3 Do not allow children to replace batteries without adult supervision
23.4 Do not short-circuit batteries
23.5 Do not heat batteries
23.6 Remove batteries from equipment if it is not to be used for an extended period of time
unless it is for emergency purposes
23.7 Always select the correct size and type of battery most suitable for the intended use.
Information provided with the equipment to assist correct battery selection should be
retained for reference.
23.8 Clean the battery contacts and also those of the equipment prior to battery
installation.
23.9 Ensure that the batteries are installed correctly with regard to polarity (+ and –).
23.10 Remove exhausted batteries promptly.
23.11 Do not dismantle batteries
23.12 Do not dispose of batteries in fire except under conditions of approved and
controlled
Incineration
23.13 Batteries may be disposed of via communal refuse arrangements provided no local
rules to
the contrary exist.
WARNING: This heater is not equipped with a device to control the room temperature. Do
not use this heater in small rooms when they are occupied by persons not capable of
leaving the room on their own, unless constant supervision is provided.
FEATURES:
1. High quality plastic shell and long using life.
2. PTC ceramic heater elements, high efficiency heating, quickly heating, noiseless,
odor-free, non-polluting, no flame and will not killing the oxygen.
3. Two level heat setting, you can arrange the temperature as your preference.
4. There is temperature fuse for fear of overheating and motor overheat protection.
Automatically turn off when the wind outlet is blocked and turn on again when the sundries
are cleared away.
5. Natural/hot wind for selection. You could close the heat element in summer; the
heater could blow cool wind.
6. Safety thermostat. Overheat protection.
INSTALLATION
Drill two holes in wall and have a distance of above 2.0m from the ground, the diameter
of the hole just contained the expansion bolt, which the diameter is 6mm. After tucked the
expansion bolt, fixed pothook on the expansion bolt with screw. Make sure pothook should
be inserted the bottom. See the drawing as following for a better understanding. (see the
picture)
Use the machine's components (screws and expansion pipe) fix on the wall as following
figure, then mounted the machine.
15/38
To Next Page
Loading...