4
4
22
22
20
0
5
ft
m
C
B
2. Attaching the lens
Line up the lens mount alignment mark with
mark on the camera to fit the lens in place,
then rotate it in the direction of the arrow until it
clicks into place.
Removing
While sliding the lens release button back ,
rotate the lens counter clockwise until it stops
and lift it off.
After removing the lens from the camera body, protect both ends by attaching the
caps.
Oil, dust, fingerprints or water on the electronic contacts could result in
malfunction or corrosion. Wipe such impurities off with a clean piece of cloth.
Do not touch the distance ring or other rotating parts when attaching the lens.
When installing a lens, do not press the lens release button .
Attaching and Removing a Lens
Attaching
1. Remove the front body cap, just like
you would remove a lens, by pushing
the lens release button
backward
and then turn the front body cap
counter clockwise and lift out.
To remove the front lens cap, squeeze the shiny
sections together and lift out.
To remove rear lens cap turn it counter clockwise.
To Next Page
Loading...
