Mammoth Classic - Cleaning and Maintenance; Cleaning the Ozone Plate; Cleaning the Ionizer and Fan; Cleaning the Pre-filter

Mammoth Classic
TM
Air Purier User Guide
© 2015 Mammoth Classic Air Purier | Version 2015
10
When the air purier no longer produces enough ozone to be effective, the ozone
plate should be cleaned (unless it has burnt spots, then the ozone plate should be
replaced). A good rule of thumb is to clean the ozone plate every month if used
continuously.
To clean the ozone plate, rst turn the unit OFF and UNPLUG from outlet. Then
remove the ozone plates from back of unit. Pull plates rmly in the center to
remove from the slot. With plate rmly supported in the hand apply a solution of
warm water and ammonia (50/50 solution is suggested) or a strong grease cutting
detergent. Scrub with a stiff brush if necessary. Be careful not to drop the plate or
scrub off the silicon. Clean both the metal screen and the ceramic tile. Rinse plate
in hot water and DRY COMPLETELY before installing. If available you may use a
hair dryer to dry the plate. Reinstall plate, making sure it is secured and ush with
the back of the unit.
If the ozone generator is making excessive noise or excessive sparks is visible,
ozone plate should be replaced (even if no burnt mark is present).
To clean needlepoint ionizer, rst turn OFF and UNPLUG from outlet. Remove
the fan grill cover. The needle point ionizer will be easy to nd in front of the fan
by looking for two pieces of wire. Take a q-tip or cotton swab dipped in alcohol
and clean any dust that may have accumulated on the needlepoints. This process
may be done when plates are being cleaned. While you have the front grill cover
off the unit you may also clean the fan and grill itself. To clean the fan, simply
wipe the blades with a damp cloth or vacuum. The grill cover may also be cleaned
with warm soapy water. Be careful that the fan grill cover is completely dry before
installing.
To clean the pre-lter, simply wipe down the surface to remove all the bigger
particles. Do not rise the lters as water will damage the HEPA and Carbon lter
inside. If the Mammoth Classic Air Purier is continuously ON, replace lter every
6 months. The replacement lter can be purchased at an affordable price at www.
mpurier.com or call (800) 470-4201.
NOTE: If you have purchased extra replacement lter in advance, keep the lter
in the original packaging since exposure to open air will start the life cycle of the
air lter.
CLEANING AND MAINTENANCE