Mammoth xC - Page 9

9
Visit us at: www.mpurier.com For Question Call: 800.470.4201
MAMMOTH xC User Manual
The two available options are:
- Timer to turn Air Purier (Fan) On/O at a pre-dened time
- Timer to turn Ozone On/O at a separate pre-dened time
Using Timer to turn Air Purier (Fan) On/O & Ozone On/O
Generally speaking, you can and should run your air purier continuously. It will take time
for the air purier to cycle through the air in the space it is in. The air purier is design to
run continuously without stopping.
Ozone has it’s benet and drawbacks. More detail about ozone is explained on another
section of this user manual. A recommend setting is to leave the ozone on while no one is
present and have ozone shut o about 30 minutes before anyone enters the space again.
1. Make sure the current time is correct.
2. Press Time/Set for at least two (2) seconds, this will cause the time to blink as well as
the specic timer to blink below the time display (Unit On time -> Unit O time -> Ozone
On time -> Ozone O time)
3. Adjust the hour and minutes by press UP and Down button on Fan and Ozone Button
4. Press Time/Set once done to complete the whole process.
Note: The air purier requires you to set all the timer in advance even if all you want to use
is the fan timer. The fan or the ozone timer will not be enabled unless you press the timer
button (see below). This means if you are not sure what time to set for the ozone timer
because you will not be using the ozone feature, you can set any random time you like since
it will not be enabled (since you will not enable the ozone timer).
To Enable Timer for the Unit and for the Ozone feature
To enable Fan Timer – Press Fan Timer (Note: this will enable all current congurations
except ozone.)
To enable Ozone Timer –Press Ozone Timer (Note: the ozone will only be turned on if the
unit is already ON. If the unit is OFF, the ozone timer will not turn ozone on until the air
purier is manually turned on or the Fan timer switches the machine on.)