Maintenance chart
42
ALWAYS COMPLY WITH SAFETY REGULATIONS
Maintenance jobs
Maintenance cycles *
1 2 3 4 5 6 7 8 9
Check coolant level and oil level in engine D
Check air filter contamination D
Change engine oil (see also page 43) D d d d
Change oil filter cartridge (see also page 43) D d d d
Clean fuel strainer D D
Draining fuel filter / condensation (earlier if severe operating condi
tions demand it)
D
Check and if necessary correct V-belt tension D D
1st retightening of cylinder head bolts (with overhauled engine) D
Check that removable unions (bolts, hose clips, pipe fittings) are firmly
in position and, if necessary, retighten
D D
Service the air cleaner (earlier if severe operating conditions demand
it)
D
2nd retightening of cylinder head bolts (with new or overhauled en
gine)
D
Check and if necessary adjust valve clearance D D D
Change disposable fuel filter / filter elements D
Check turbocharger D
Change coolant D
Renew filler cap and working valve of cooling system D
Check injection nozzles D
* 1 - Daily
2 - After the first 10 to 20 hours of operation (with new or overhauled engine)
3 - Every 200 hours of operation
4 - After the first 400 hours of operation
5 - Every 400 hours of operation
6 - Every 1000 hours of operation
7 - Every 3000 hours of operation
8 - Every 2 years
9 - Every 6000 hours of operation
d Change interval in operating hours depends on quality of oil used, see page 43.
To Next Page
Loading...
Need help?
General
