General Safety Instructions
23
Carefully read the Operating Instructions before starting any work!
This is especially valid for the chapter on General Safety Instructions
and the safety instructions in each of the chapters.
2.10 Signs
The following symbols should be installed in the immediate vicinity of the hazard area.
WARNING!
Risk of injury caused by illegible symbols!
Stickers and symbols can become dirty or made otherwise illegible in the course of time!
For this reason:
S Always keep the safety, warning and operational signs in good legible condition.
S Clean or replace illegible safety, warning and operational signs.
Electric Voltage
Rooms marked with this symbol may only be accessed by qualified electricians.
Unauthorised persons may not enter these rooms.
Hot Surfaces
Hot surfaces such as hot engines and hot fluids may not always be recognisable. Do not
touch these surfaces without protective gloves.
To Next Page
Loading...
