4
2. Insert the source HDD in Bay
A and the target HDD n Bay B.
NOTE: The capacity of the
target (slave) HDD must be
greater than the capacity of
the source (master) HDD;
otherwise, the cloning can not
be properly completed.
3. When the A and B LEDs light,
toggle the Power switch (on
the rear panel) to On.
4. Press the Clone button for
3 seconds. When the LED
lights, press the Clone button
again. The LEDs will light to
indicate progress (25%, 50%,
75% and100%). All the LEDs
will light when the cloning
process is complete.
5. Turn the power off and
remove the drives.
Front view: LED indicators
Top view: HDD bays
POWER
DISK
MASTER
25% 50% 75% 100%
DISK
SLAVE
Bay A
(master/source)
Bay B
(slave/target)
Clone
button
To Next Page
Loading...