What to do if my Manhattan Plaza HD-52 says ‘No signal’?
If you're seeing a ‘No signal’ message on your Manhattan Receiver, check the cable connections at both the receiver and the satellite dish. Inspect the dish for any damage or if it's in the wrong position.
What to do if there is no picture or sound on my Manhattan Plaza HD-52?
If there's no picture or sound on your Manhattan Receiver, first, check the HDMI/SCART cable connections at both the receiver and your television. Also, make sure your television is switched to the correct HDMI/SCART input.
What to do if there is no set up screen on my Manhattan Plaza HD-52?
If you don't see the setup screen on your Manhattan Receiver, ensure the receiver is switched on and the mains adapter is plugged in and the mains socket is turned on. Verify that the HDMI/SCART cable is properly connected to both the receiver and the television. Finally, check that your television is set to the correct HDMI/SCART input.
Why Manhattan Plaza HD-52 is not responding to the remote control?
If your Manhattan Receiver isn't responding to the remote control, ensure the receiver is switched on and not in standby mode. Aim the remote directly at the receiver. Also, check for any obstructions blocking the remote sensor on the front of the receiver.
Why is my Manhattan Plaza HD-52 Receiver TV picture not HD?
If your TV picture is not HD on your Manhattan Receiver, first, make sure you're tuned to an HD channel. If your TV isn't HD-capable, connect the receiver to an HD-Ready TV. If you're using a SCART cable, connect the TV with an HDMI cable instead.
Why won’t BBC iPlayer or ITV Player load on my Manhattan Plaza HD-52?
If BBC iPlayer or ITV Player won’t load on your Manhattan Receiver, check your broadband connection and network configuration in the system menu.
What causes signal lock failed on Manhattan Plaza HD-52 Receiver?
If the signal lock failed on your Manhattan Receiver, check the cable connections at the receiver and the satellite dish. Ensure the dish is correctly positioned.
How to fix no picture via HDMI on Manhattan Receiver?
If you have no picture via HDMI on your Manhattan Receiver, it might be due to an incompatible HDMI resolution. While the receiver is on, press and hold the button for 10 seconds; this will change the resolution to 720p.
What to do if I cannot view a channel on my Manhattan Plaza HD-52?
If you cannot view a channel on your Manhattan Receiver, make sure you're using the correct channel number by choosing the channel from the Channel List. If the channel is locked, enter your PIN.
Why is the full picture not visible on my Manhattan Receiver?
If the full picture is not visible on your Manhattan Receiver, it could be due to a mismatched screen format or how the program is being broadcast. Use the Picture menu to choose the correct screen type and display mode to suit your TV.
Contact information and support hours for technical assistance with the receiver.
Instructions on connecting the receiver to a satellite dish.
Steps for connecting the receiver to a TV, power, and internet.
Turning on the receiver, TV, and setting up initial picture settings.
Checking satellite signal lock and entering postcode for regional variations.
Scanning for Freesat channels and setting up a PIN for security.
How to power the receiver on/off and change channels using various methods.
Connecting the receiver to a broadband internet connection via Ethernet.
Accessing and navigating On Demand TV services through channels or the programme guide.
Manual or automatic scanning for non-Freesat channels using frequency details.
Specific safety instructions for thunderstorms and electrical safety.
To Next Page
General
