Need help?Do you have a question about the Manhattan Plaza ST 100 and is the answer not in the manual?
Critical warnings for safe operation and to prevent damage.
Steps to connect and tune the receiver output to a TV via UHF.
Overview of the primary menu system for receiver configuration.
Set up LNB type, power, and DiSEqC for satellite reception.
Specific instructions for setting up wideband LNBs with skew adjustments.
Manually control satellite dish positioner using DiSEqC 1.2.
Automatically position satellite dish using USALS.
Automatic scanning for TV and radio channels across satellites.
Manually scanning for channels using DiSEqC 1.2.
Adjusting LNB skew for optimal signal during manual search.
Searching for channels with incomplete or unknown data.
Methods for switching between channels and satellites.
Creating and managing custom lists of preferred channels.
Restoring the receiver to its original factory configuration.
Setting up parental controls and PIN protection for menus/channels.
To Next Page
General
