Manhattan T4-R - Remote Learning and Resetting; Remote Learning Setup Steps; Resetting the T4-R Remote

17
Learning Steps
Before Stating
• Set your T•R's volume to maximum to ensure the correct volume level from
your TV ater learning is complete.
• Put your T•R in standby to avoid it responding to the T•R remote during the
learning steps.
• Place your T•R and TV remotes on a lat suface, facing each other, a small
distance apat.
. Press the SAD and ZOOM butons on the T•R remote for  seconds to enter
learning mode.
→ The buton on the T•R remote will glow blue.
. Press the buton on the T•R remote you want to teach: Volume +, Volume –,
Mute, TVAV or TV .
→ The buton on the T•R remote will stat blinking.
. Press and hold the corresponding buton on the TV remote.
→ If successfully learnt, the light from the buton on the T•R remote will
turn o for a second, then turn solid blue.
→ If it fails to be learnt, the light from the T•R remote's buton will lash 
times, and you will need to repeat Step .
. Repeat steps  and  for all the butons to teach.
. Press OK on your T•R remote to exit learning mode.
→ The light from the T•R remote’s buton will turn o.
Test each buton with your TV. If a buton does not work, repeat the steps to teach
it again. Please note that some TVs use non-standard remote signals and may not
be compatible with the T•R remote.
Resetting Your T4•R Remote
To reset all programmed butons and return them to their original state, press and
hold the SAD and RED butons for  seconds until the buton blinks blue.