3-30
H OCCASIONAL MAINTENANCE
H1 - Fuel feed circuit (*)
BLEED
H2 - Wheel
CHANGE
For this operation, we recommend that you use the MANITOU hydraulic jack,
Reference 505507, and the MANITOU safety stand, Reference 554772.
- If possible, stop the platform on a stable, level surface.
- Proceed to stop the platform (see: 1 – SAFETY INSTRUCTIONS AND ADVICE: DRIVING INSTRUCTIONS WHEN LADEN AND UNLADEN).
- Chock the platform in both directions on the axle opposite the wheel to be changed.
- Loosen the nuts on the wheel to be changed until they can be removed quite easily.
- Set the jack on the axle carrier as close as possible to the wheel and then adjust the jack (Fig. G2/1).
- Lift the wheel until it detaches slightly from the ground and set the safety stand under the axle (Fig. G2/2).
- Fully loosen the nuts on the wheel and remove them.
- Release the wheel by moving it to and fro and roll it to one side.
- Slide the new wheel on to the hub.
- Screw up the nuts by hand and grease them if necessary.
- Remove the safety stand and lower the machine using the jack.
- Tighten the wheel nuts with a torque wrench.
*(Contact your dealer)
647367 (01/03/2017)
100/120 SC-2 / 140 SC
To Next Page