3-16
Test Limited Drive Speed
26- Push and hold the lift function enable button.
Raise the platform approximately 1.8 m from the ground.
27- Press and hold the function enable switch on the control handle.
28- Slowly move the control handle to the full drive position.
> Result: The maximum achievable drive speed with the platform raised should not exceed 22 cm/s.
If the drive speed with the platform raised exceeds 22 cm/s, immediately tag and remove the machine from service.
Test the Tilt Sensor Operation
Note: Perform this test from the ground with the platform controller. Do not stand in the platform.
29- Fully lower the platform.
30- Drive both wheels on one side onto a 10 cm block or onto a curb.
31- Raise the platform at least 1.8 m.
> Result: The platform should stop and the tilt alarm will sound at 180 beeps per minute. The indicator light on the lift
function enable button will be red.
32- Move the drive control handle in the direction indicated by the blue arrow, then move the drive control handle in the direction
indicated by the yellow arrow.
> Result: The drive function should not work in either direction.
33- Lower the platform and drive the machine off the block.
Test the Emergency Lowering
34- Push and hold the lift function enable button and raise the platform approximately 60 cm.
35- Push in the red Emergency Stop button to shut off the engine.
36- Pull out the red Emergency Stop button to the on position.
37- Push and hold the lift function enable button.
Activate the up/down rocker switch in the direction indicated by the yellow arrow.
> Result: The platform should lower.
647367 (01/03/2017)
100/120 SC-2 / 140 SC
To Next Page