2-28
ATTACHMENT CIRCUIT
ATTACHMENT CIRCUIT UNLOCKED (by default)
ATTACHMENT CIRCUIT LOCKED
It is recommended to use this function when the lift truck is not fitted with hydraulic attachment.
ATTACHMENT CIRCUIT IN CONTINUOUS MODE
The indicator
will light when it is in use.
By default, the attachment circuit in continuous mode is disabled as soon as the operator leaves the cab. This condition can be changed from the OPT
menu on the menu screen.
- The operating screen displays the enabled mode. Press the button to display the other available mode(s).
NOTE: On stabilizers, the display in zone 2 on the operating screen switches to zone 6/7.
CHANGE MODE
88°
88
ON TYRES
Press
1
2
1
2
Confirm
Cancel
88°
88
88°
88
ON TYRES
Press
1
2
1
2
Confirm
Cancel
88°
88
88°
88
ON TYRES
Press
1
2
1
2
Confirm
Cancel
88°
88
ADJUSTING THE ATTACHMENT CIRCUIT HYDRAULIC FLOW RATE IN CONTINUOUS MODE
- The pictogram
flashes, and switches to the setting screen
XX%
i
as soon as
hydraulic flow rate is selected using button A on the attachment hydraulic control lever.
- Button A forward for positive percentage (+ XX %), backward for negative percentage
(XX %).
- Hold button A in the same position for 2 seconds to confirm the chosen hydraulic flow
rate
+XX%
.
- Press the button
, or actuate button A, or switch off the I.C. engine to return to the
screen with the flashing pictogram
88°
88
and thus disable continuous mode.
A
To Next Page
Loading...
