2-48
DESCRIPTION AND USE OF THE OPTIONS
1 - NUMBER PLATE LIGHTING
2 - PREHEATING ELEMENT
3 - FINTRONIC ANTI-START SYSTEM
4 - MODCLE ANTI-START SYSTEM
5 - ELECTRICAL PROVISION ON JIB
6 - QUICK-RELEASE COUPLER ON ATTACHMENT CIRCUIT
7 - ANGULAR SECTOR ON JIB
8 - EXTERIOR DRAIN-BACK
9 - HYDRAULIC ATTACHMENT LOCKING
10 - JIB HEAD ELECTROVALVE
11 - JIB HEAD ELECTROVALVE + HYDRAULIC ATTACHMENT LOCKING
12 - SINGLE SIDE-SHIFT CARRIAGE (TSDL)
13 - SINGLE OR DUAL EFFECT REAR HYDRAULIC CONTROL PREDISPOSITION
14 - LIFTING RING ON SINGLE CARRIAGE
1 - NUMBER PLATE LIGHTING
2 - PREHEATING ELEMENT
Enables the engine to be kept warm during prolonged periods of stoppage and thus
improves engine starting.
SUPPLY CHARACTERISTICS OF PREHEATING SYSTEM:
• Rated range of power: 220-240V; 50-60Hz
• Current consumed: 4,5A
• Equipment in class 1
• Equipment connectable only on feeder circuit TT or TN
• Category of insulation 2
ENVIRONMENTAL CONDITIONS FOR USE:
• Maximum ambient temperature for using preheating: +25°C
• Pollution level 2
CONDITIONS FOR CONNECTION AND USE OF PREHEATING:
- The preheating system should not be used for an external ambient temperature higher than + 25°C.
- It is essential that the power supply to the preheating system is:
• Effected with a cable that conforms to the installation standards in force and contains a protective earth conductor.
• Contains an appropriate sectioning system.
• Incorporate an appropriate safety system against short circuits (fuses or circuit breaker) and a differential circuit breaker
with 30 mA sensitivity.
- Only connect to and disconnect from the power supply while the unit is off and the I.C. engine is stopped.
To Next Page
Loading...
