32
Preparation of Remote Control
Place the remote control on an even
surface and insert the supplied batteries
into the remote control as follows.
1. Softly push the back cover to open the
battery compartment.
2. Insert two batteries(1.5V size AAA),
please make sure the polarity matches
the marks inside the compartment.
3. Softly press the back cover to close it.
Using of Remote control
Point the remote control unit from on more
than about 7m from the remote control
sensor and within about 60 degrees of the
front of the unit.
The operating distance may vary
depending to the brightness around.
Under normal use the battery will last
for six months.
Take out battery when the remote is
not in use for a long time.
Do not point bright lights directly at
the remote control sensor.
Do not place objects between the
remote control unit and the remote
control sensor.
Do not use this remote control unit
while simultaneously operating the
remote control unit of any other
equipment.
To Next Page
Loading...
Need help?
General
