MantelMount MM700 - Wall Plate and Lifting Mechanism Installation; Position and Mark Wall Plate Holes; Pre-drill Mounting Holes; Secure Wall Plate to Studs

Minimum Height
from STEP 9
Align the arrows on the Wall Plate {32} pointing upward.
Center and level the plate above mantle and position the
height using the table in STEP 9. Mark the 4 spots for lag
bolts directly on center of studs.
12
Pre drill the 4 holes with 11/64” drill bit to a depth of
2.5 inches (65mm) including wall covering. Note: Wall
covering (drywall) must not exceed 5/8” thickness.
13
14
Attach the Wall Plate {32} using Lag Bolts {17} and
Washers {10} directly into the centers of the studs.
15
!
CAUTION:
Do Not overtighten Lag Bolts {17}. Tighten only until the
washers are firmly against the wall plate. Damage due to
overtightening can cause property damage or injury.
Insert top tabs of Lifting Mechanism {35} into the slots of
Wall Plate {32} then slide bottom into position. Align all
four holes and install Screws {14}. Tighten Securely.
1
2
DO NOT
damage or scratch
the rods of the
Gas Springs!
PAGE 8 MantelMount MM700