9.2 Chain does not run: Check position of handguard (see ill. 8). Chain
only runs if handguard brake is released.
9.3 Chain does not cut at all : Chain is not mounted in the correct direc-
tion. Assemble the chain in the correct direction.
9.4 Sparks y at the motor: Motor or carbon brushes damaged. Take
the chainsaw to a specialized work-shop or the works after-sales
service.
9.5 Oil does not ow: Check the oil level. Clean the oil ow openings in
the bar (see also the corresponding hints of “Maintenance and ser-
vicing). If this is not successful, take the chainsaw to a specialized
work-shop or the works after-sales service.
Attention: Any maintenance or repair work going beyond that
described in these Operating Instructions may only be carried
out by authorized persons or the works after-sales service.
Attention: If the power supply lead of this device shows any
defects, the lead must be replaced by an authorized repair
shop only or through the manufacturer’s own service per-
sonel, as this work requires special tools.
10. Repair Service
Repairs to electric power tools should only be carried out by specialist
electrical personnel.
Always keep the original packaging for a possibly required shipping of
the tool.
11. Environmental Protection
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycling center and disposed of in a manner which
is compatible with the environment.
If your chainsaw should become useless somewhere in the
future or you do not need it any longer, do not dispose of the
device together with your domestic refuse, but dispose of it
in an environmentally friendly manner. Please dispose of the
device itself at an appropriate collecting/recycling point.
By doing so, plastic and metal parts can be separated and
recycled. Information concerning the disposal of materials and
devices are available from your local administration.
Properly dispose of packaging material that is not required any
longer via your local waste paper disposal system.
12. Technical Data
Electric Chainsaw Mantis 8530
Rated Voltage V~ 120
Nominal Frequency Hz 60
Rated Output W 1400
Nominal current A 11.7
Guide Bar in 15.75
Cutting length in 15
Speed fps approx. 34.8
Weight Ibs 11.5
Oil oz 8.5
All models with automatic chain lubrication and mechanical chain brake
and rundown brake.
Attention: This chain saw is only intended for cutting wood !
14
To Next Page
Loading...
General