11
8.1
8.2 8.3
Push the drive gear through the tube in the drive support with the gear on the inside of the drive support.
Insert the handle bar in the drive gear and
fasten it with the cotter pin.
Use the pliers to bend the pin leg as shown
below.
WHAT YOU’LL NEED
Tools: Plain (or needle nose) pliers
Hardware: 8a - (1) Cotter pin
Parts: Item 8 - (1) Drive support
Item 13 - (1) Drive gear
STEP 8 – INSTALLING THE DRIVE GEAR
To Next Page
Loading...
