Mantis COMPACT ComposTumbler CT02001 - STEP 9 - INSTALLING THE DRIVE SUPPORT; STEP 10 - ATTACHING THE FRAME

12
WHAT YOU’LL NEED
Tools: None
Hardware: None
Parts: Drive gear and support assembly from step 8.
Assembled Drum from step 6
WHAT YOU’LL NEED
Tools: Adjustable wrench
9/16” wrench
Hardware: 10a - (2) 3/8” x 1-1/2” Fender washer
10b - (2) 3/8” Two way locknut
10c - (2) 3/8” x 4” Hex head cap screw
Parts: Item 16 - (2) Stub axle
Item 11 - (2) Frame leg
STEP 9 – INSTALLING THE DRIVE SUPPORT
STEP 10 – ATTACHING THE FRAME
9.1
Guide the drive gear into the guide recess of
one endcap as shown.
10.3
Insert one of the frame legs into the
open end of the drive support and
align the holes.
10.4
10.5
Fasten the frame leg, drive support, and
endcap using the hex cap screw, washer,
and locknut. Tighten the hardware with the
adjustable and 9/16” wrenches. Note: The
washer and nut should be on the inside of
the drum.
From inside the drum, insert one of the stub axles
through the center hole in the endcap.
10.1
Stub axle
(seen from inside drum)
10.2
On the outside of the endcap, position
the drive support into the channel on
the end of the stub axle
Drive support in stub
axle channel (seen from
outside drum)
Repeat steps 10.1 through 10.4 for
the other end.