Mantis COMPACT ComposTumbler CT02001 - STEP 11 - COMPLETING THE FRAME

13
WHAT YOU’LL NEED
Tools: Adjustable wrench
7/16” wrench
Hardware: 11a - (1) ¼-20 x ¾” Hex head cap screw
11b – (6) ¼-20 x 1-1/2” Hex head cap screw
11c – (7) ¼ Medium split lock washer
11d – (7) ¼-20 Hex nut
Parts: Item 12 - (2) Strut
Item 10 - (2) Brace
STEP 11 – COMPLETING THE FRAME
Positiontheattenedfaceofastrutagainsttheoutsideofthedriveassemblyand
fastenwitha1-12”hexheadcapscrew,lockwasher,andhexnut(ngertighten
only at this point). Note: You should use the end of the strut that does not have a
second hole close to the end.
Push a hex screw through the hole in the end of the frame leg and attach the other
end of the strut. Note: Do not add any washers/nuts at this time.
Repeat with the second
strut on the other side.
11.1
11.3
11.2
Strut