General operating indications
DESCALING SIGNAL:
• When warning light D blinks YELLOW and the machine beeps 3 times, a descaling cycle
should be carried out (see ch. Descaling).
HEATING:
• Buttons A-B-C blink simultaneously.
WHEN THE WATER RUNS OUT DURING OPERATION:
• The water tank is empty when warning light D blinks RED and the appliance emits 3
beeps followed by a single intermittent beep.
• Fill the water tank with fresh, still water (Fig. 4).
• Press one of the buttons A-B-C. Wait for the machine to complete the priming cycle and
fi ll with water.
• When buttons A-B-C turn on and remain steadily lit, the appliance is ready for use.
IF THE LEVER IS RAISED WHILE DISPENSING:
• Raising the lever while dispensing a product (Fig. 1) may cause splashes of hot water.
Danger of scalding!
• Warning light D blinks RED and the intermittent machine beeps. The appliance will
immediately stop dispensing.
• Close the lever (Fig. 3).
• Press one of the buttons A-B-C to reset the alarm.
• The appliance is ready for use again.
Adjusting the cup/espresso cup height
• The machine can be adjusted for the use of large cups or espresso cups.
• The machine is initially set for the use of large cups (Fig. 7).
• For optimum results when using espresso cups, lower the end of the dispensing spout
(Fig. 10), or lift and twist the rack above the drip tray (Fig. 13).
Correct use of the buttons
To dispense “Espresso” or “Caffè crema”, only use button A or B (lit in WHITE). The same
buttons, depending on the quantity, are to be used for dispensing capsules of orzo, ginseng,
cocoa or milk.
NOTE: traces of the product just dispensed may remain inside the machine. When
dispensing milk, hot chocolate or instant beverages, for full fl avour we suggest
rinsing the machine by pressing any button (A , B or C) without inserting a capsule.
In any case, we recommend carrying out this procedure at least once a week.
9
To Next Page
Loading...
