Dispensing coffee
• Raise the lever to open the capsule compartment (Fig. 1).
• Insert the capsule, pressing it gently into place (Fig. 2).
• Close the lever fully (Fig. 3).
• Place a cup or espresso cup under the coffee dispensing spout (Fig. 7 or 8).
• Press and release button A, orBC, depending on the desired coffee.
• The pressed button will fl ash. The machine will stop dispensing on reaching the
programmed quantity and emit a beep.
We recommend a maximum of 60mls for coffee
• Raise the lever to eject the used capsule into the drawer (Fig. 1).
• Close the lever (Fig. 3).
NOTE: the quantities of coffee dispensed can be programmed according to personal
taste and the size of the cups or espresso cups used.
To program the quantities, please refer to ch. "Programming the quantity of coffee in
a cup".
Programming the quantity of coffee in a cup
• Raise the lever to open the capsule compartment (Fig. 1).
• Insert the capsule, pressing it gently into place (Fig. 2).
• Close the lever fully (Fig. 3).
• Place a cup or espresso cup under the dispensing spout (Fig. 7 or 8).
• Press and hold the desired coffee button.
• On reaching the desired amount of coffee, release the button. Now the button is
programmed. The quantity of coffee dispensed can be programmed from a minimum
of 20 up to a maximum of 250 ml.
• Raise the lever to eject the used capsule into the drawer (Fig. 1).
• Close the lever (Fig. 3).
Saving energy
The machine will automatically reduce consumption after 1 hour of inactivity. Buttons
A-B-C blink slowly and sequentially. To restore normal operating conditions, press
any button or raise the lever. The appliance will start warming up.
When buttons A-B-C turn on and remain steadily lit, the appliance is ready for use.
Daily maintenance
• Remove the drip tray and used capsule drawer (Fig. 6).
• Lift the used capsule drawer (Fig. 11); empty and rinse it.
• Remove the grid (Fig. 12). Empty the drip tray and rinse it out with water.
• Remove the water tank (Fig. 5); empty and rinse it.
• Remove the dispensing spout by twisting it slightly and pulling fi rmly downwards (Fig. 16).
Wash it in hot water.
NOTE: traces of the product just dispensed may remain inside the machine. When
dispensing milk, hot chocolate or instant beverages, for full fl avour we suggest
rinsing the machine by pressing any button (A , B or C) without inserting a capsule.
In any case, we recommend carrying out this procedure at least once a week.
Use a soft cloth and a neutral
detergent to clean the surfaces
of the appliance. Do not use
jets of water to clean the
appliance.
The plastic parts of the machine,
including the water tank, are NOT
dishwasher safe.
10
capsules for optimal extraction and flavour.
To Next Page
Loading...
