Maple Systems HMI5043L User Manual

1010-1018 Rev 10 www.maplesystems.com
Introduction
Thank you for purchasing a Maple Systems HMI5000L Series graphic
industrial operator interface terminal. This booklet describes the steps
necessary for installing the following models:
• HMI5043L
• HMI5043LB
• HMI5043DL
• HMI5070DL
• HMI5070L
• HMI5070LB
• HMI5070NL
• HMI5071L
• HMI5097DXL
• HMI5097NXL
• HMI5100L
• HMI5102L
• HMI5103L
• HMI5121XL
• HMI5150XL
The HMI5000L Series touchscreens are configured using the
EasyBuilder Pro Software.
For information on programming and configuring the HMI, please refer to
the EasyBuilder Pro Programming Manual available for free download
on the Maple Systems website in the Support Center.
For additional information, please refer to the Support Center section of
the Maple Systems website, www.maplesystems.com/support.
The Support Center provides links to information such as Software
Downloads, Manuals, FAQs, Technical Notes, Training Videos, Sample
Projects, Controller Information Sheets, Controller Cables, and more.
HMI5000L Series
Installation Guide

Maple Systems HMI5043L Specifications

General

Brand	Maple Systems
Model	HMI5043L
Category	Recording Equipment
Language	English

Summary

Introduction to HMI5000L Series

Safety and Handling Procedures

Static Awareness Precautions

Procedures to minimize electrostatic discharge during HMI handling for safety and to prevent damage.

Environmental and Safety Precautions

General Safety Precautions

Critical safety warnings and precautions for HMI installation and electrical connections.

Connectivity and Power Management

Cable Routing and Noise Immunity

Power Supply Selection Criteria

Grounding and Installation Procedures

Control Panel Grounding

Importance and procedures for establishing a good, high-integrity earth ground for the HMI and control panel.

HMI Power Connection

Connecting the HMI to Power

Detailed steps for connecting the HMI to a DC power supply using the 3-position connector.

Panel Mounting Instructions

Panel Preparation for Mounting

Mount the HMI to the Panel

Instructions for physically attaching the HMI to the control panel using mounting clamps.

Ethernet Network Configuration

Ethernet Network Setup Steps

Serial Port Pinout Diagrams

Serial Port Pinout Diagrams

Dual Ethernet Port Configuration

Dual Ethernet Port Setup Guide

Configuration steps for HMIs with two Ethernet ports, ensuring they operate on separate subnets.

Wi-Fi Connectivity Configuration

Wi-Fi Connectivity Setup

Instructions for enabling and configuring Wi-Fi connectivity on the HMI5103L.

Connecting to a Wi-Fi Network

Steps to connect the HMI to a Wi-Fi network by selecting SSID, entering password, and security mode.