9.1ch +
Front B:
0
The Pre Amplifier of this unit is assigned to 2 channels
for connecting to the second front speaker.
0
You can switch between the desired combination of
front speakers A and front speakers B. (v
p. 220)
Switch the front speaker using the “Front Speaker”
setting. (v
p. 220)
Dolby
Atmos :
0
Setting to assign the Pre amplifiers within this unit for
the speaker layout suitable for Dolby Atmos playback.
(v p. 223)
o
Detailed settings when “Assign Mode” is set to
“11.1ch”
When “Assign Mode” is set to “11.1ch”, set the following items.
n
Height Speakers
Select the number of the height speakers used in MAIN ZONE.
2 Height Speakers
(Default):
Uses a set of (two) height speakers.
4 Height Speakers : Uses two sets of (four) height speakers.
Using Dolby Speakers :
Uses a Dolby enabled speaker placed on
the floor.
Contents Connections Playback Settings Tips Appendix
215
Front panel Display Rear panel Remote Index
To Next Page
Loading...
