Marantz AV7702 - Bi-Amp and Height Speakers

o
Detailed settings when “Assign Mode” is set to
“9.1ch (Bi-Amp)”
When “Assign Mode” is set to “9.1ch (Bi-Amp)”, set the following items.
n
Pre-out for Bi-Amp
Select the PRE OUT connectors used for the bi-amp connection of
front speakers.
FRONT WIDE/
HEIGHT2
(Default):
Make the bi-amp connection by using the FRONT
PRE OUT connectors and FRONT WIDE/
HEIGHT2 PRE OUT connectors.
HEIGHT1:
Make the bi-amp connection by using the FRONT
PRE OUT connectors and HEIGHT1 PRE OUT
connectors.
SURROUND
BACK:
Make the bi-amp connection by using the FRONT
PRE OUT connectors and SURROUND BACK
PRE OUT connectors.
n
Height Speakers
Select the number of the height speakers used in MAIN ZONE.
None: Uses no height speakers.
2 Height Speakers
(Default):
Uses a set of (two) height speakers.
4 Height Speakers: Uses two sets of (four) height speakers.
Using Dolby Speakers:
Uses a Dolby enabled speaker placed on
the floor.
Contents Connections Playback Settings Tips Appendix
218
Front panel Display Rear panel Remote Index