o
Front
Set the size of the front speakers for 2-channel playback.
Large
(Default):
Use a large speaker that can adequately play back
very low bass frequencies.
Small:
Use a small speaker that has inadequate playback
capacity for very low bass frequencies.
When “Speaker Config.”-“Subwoofer” in the menu is set to “None”, “Large” is
automatically set.
(
v
p. 224)
o
Subwoofer
Set the presence of a subwoofer.
Yes
(Default):
Use a subwoofer.
No: Select when a subwoofer is not connected.
When “Speaker Config.”-“Subwoofer” in the menu is set to “None”, No is
automatically set. (v p. 224) If the “Front” setting is “Small”, the setting is
automatically “Yes”.
o
SW Mode
Select low range signals to be reproduced by subwoofer.
LFE
(Default):
When “2ch Playback”-“Front” is set to “Large”, only
LFE signals are output from the subwoofer. Also,
when “2ch Playback” - “Front” is set to “Small”, the
front channel low range signals are added to the
LFE signals and output from the subwoofer.
LFE+Main:
The front channel low range signal is added to the
LFE signal output from the subwoofer.
This can be set when “2ch Playback”-“Subwoofer” is set to “Yes”.
Contents Connections Playback Settings Tips Appendix
233
Front panel Display Rear panel Remote Index
To Next Page
Loading...
