Switching the function of the volume buttons on the remote control
If connecting a power amplifier to the analog audio output terminals
(VARIABLE) of this unit, you can change the operation mode of the
included remote control so that the volume of the power amplifier can be
adjusted from this unit. There are two remote control operation modes:
amplifier operation mode and network CD player operation mode.
Amplifier operation mode adjusts the volume of a Marantz amplifier and
network CD player operation mode adjusts the volume of the audio signal
output from the analog audio output terminals (VARIABLE) of this unit. The
factory default setting for the remote control operation mode is the
amplifier operation mode.
0
Be sure to check the operation of each unit after setting the remote control
operation modes.
0
Switch between the remote control operation mode settings by pressing the
VOLUME no and : buttons.
0
The remote control operation modes returns to the default settings when the
batteries are removed. Set the remote control operation modes again after
replacing the batteries.
Contents Connections Playback Settings Tips Appendix
109
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
