0
When “TV Input” is set in the setup menu, this unit automatically turns on when the
TV connected to the unit is turned on, and the input source switches to “HDMI”,
“Coaxial” or “Optical”. (v p. 101)
0
If you connect your TV via the Optical or Coaxial connection, this unit cannot be
put to standby when you turn off your TV. If you want to automatically put this
device on standby, set “Auto-Standby” in the setup menu. (v p. 103)
NOTE
0
Do not input non-PCM signals, such as Dolby Digital, DTS and AAC. This causes
noise and could damage the speakers.
0
Only the PCM 2-channel setting can be used to play sound from a TV via the ARC
function. Set "PCM 2ch" as the audio format in the TV settings.
o
Specifications of supported audio formats
See “Digital input” (v p. 139).
o
HDMI control function
Connect this unit to a TV that supports the HDMI control function with
an HDMI cable and enable the HDMI control setting on the TV to
perform basic operations on this unit (changing the input source,
turning the power on and off, adjusting the volume) with the remote
control of the TV.
Refer to “About HDMI” (v p. 142) for more information about the
HDMI control function.
Contents
Connections Playback Settings Tips Appendix
72
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
