Audio
Make audio-related settings.
Filter
This unit is equipped with a sound quality adjusting function which allows
users to enjoy the desired playback sound quality. The unit supports PCM
signal.
Filter 1
(Default):
Offers a short impulse response for both
pre-echo and post-echo. Large amount of
audio information clearly reproduces deep
stereo imaging and the relative position of
the sound source.
Filter 2:
This characteristic is known as
asymmetrical impulse response. The post
echo is slightly longer than the pre-echo.
The sound characteristics is more analog
like.
Lock Range
Narrowing down the “Lock Range” setting reduces jittering, providing
clearer sound. However, if the “Lock Range” is set too narrow, it may
cause intermittent sounds and noise during playback or when switching to
a song with a different sampling frequency. If this occurs, broaden the
“Lock Range” setting until the music you are listening to sounds normal.
Narrow / Medium / Wide
0
The factory default setting for “Lock Range” differs depending on the input source.
Below are the factory default settings for each input source.
Default Input source
Narrow
CD
Wide
HEOS Music / Bluetooth /
USB flash drive playback (USB-A) / USB-DAC /
HDMI / Coaxial / Optical
0
A separate “Lock Range” setting is recorded for each input source, except for
“HEOS Music”, USB flash drive and Bluetooth, which have a common setting.
Contents Connections Playback Settings Tips Appendix
97
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
