Power does not turn on / Power is turned off
Power is not turned on.
0
Check whether the power plug is correctly inserted into the power outlet. (v p. 24)
0
This unit is in standby mode. Press the X button on the unit or the AMP X button on the remote control. (v p. 26)
Power automatically turns off.
0
The Auto Standby mode is on. When approx. 15 minutes pass with no audio input and no operations on the unit, this unit automatically enters the
standby mode. To turn off the Auto Standby mode, press the AMP X button for 5 seconds or longer. (v p. 32)
0
When this unit and a Marantz audio device compatible with the power synchronization function are connected using a remote connection cable, the
power of this unit turns off (standby) in synchronization with the power off operation of the device connected to this unit. (v p. 22)
The power turns off and the protection circuit indicator shows one long blink and two short blinks in orange.
0
Stop playback on the playback device, and then turn the power off and on again.
0
If the problem is not solved by turning the power off and on again, this unit’s amplifier circuit has failed. Unplug the power cord and contact our customer
service center.
The power turns off and the protection circuit indicator shows one long blink and three short blinks in orange.
0
This unit’s power circuit has failed. Unplug the power cord and contact our customer service center.
Contents
Connections Playback Settings Tips Appendix
38
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
