1
1. TECHNICAL SPECIFICATIONS
Digital audio system
System
Solid State recorder
Usable Media
IC memory cards and HDD(Micro Drive) cards
Recording and reading method
MPEG1 Layer 2/3 compression
16 bit linear PCM
Recording Bit rate (Selectable by preset)
MONO/STEREO
768 kbps (PCM), 192, 128, 96, 64, 48, 32 kbps
(MPEG2/MPEG3)
192, 128, 96, 64 kbps (MPEG, Joint Stereo)
The amount of memory required per hour of recording:
Example : 64MB IC memory Card
Bit Rate
(kbps)
STEREO(minit)
PCM MP2/MP3
32 28 280
48 21 210
64 14 140
96 10.5 105
128 7 70
192 5.25 52.5
256 3.5 35
512 1.75 17.5
Sampling frequency
Analog
48 kHz/44.1 kHz/32 kHz/22.14 kHz/16 kHz
Digital
48 kHz/44.1 kHz
Number of channels
2/1 (stereo/mono)
Frequency Response
20,000 Hz ±3.0 dB (at digital)
Signal - to - Noise Ratio ( IEC - Aweighted)
80 dB
Total Harmonic Distortion (at 0 VU)
0.03 %
Dynamic Range
85dB
Inputs
MIC/LINE IN L/R
Type: XLR (1:GND, 2:HOT, 3:COLD)
Input Sensitivity (MIC): -68 dBu/9 kohms
Input Sensitivity (LINE): -20 dBu/47 kohms
LINE OUT L/R
Type: RCA jack
Input Sensitivity (LINE): -20 dBu/47 kohms
Outputs
LINE OUT L/R
Type: RCA jack
Standard level: 2 Vrms max./2 kohms
DIGITAL OUT
Type: RCA jack
Output impedance: 75 ohms
Standard output level: 0.5 Vp-p
Sampling frequency: 44.1/48 kHz
Format: SPDIF (IEC-958 Type II)
GENERAL
Headphone Output power
15 mW/32 ohms
Speaker Output Power
200 mW
Phantom Power
+48V, 5mA
Power Requirement
13 V, 1.0 A
Power Consumption
Recording: 5.2 W
Charging: 12 W
Power off: 3.5 W (Battery mode : 2 mW)
Dimensions (W x H x D)
264 x 52 x 185 mm
(10.4" x 2.0" x 7.3")
Weight
1.3 kg (2 lbs. 14 oz.)
Included Accessories
AC adaptor: 1
Battery holder: 1
Carrying Strap: 1
User Guide: 1
Optional Accessories
Ni-Cad Battery pack (RB1100PMD)
Carrying Case (CLC670PMD)
Interfce cable
To Next Page
Loading...
Need help?
General
