Marantz RC2000MKII - Page 15

3029
1. Press the MACRO w operation mode button with a
paper clip tip.
2. Press one of the MACRO buttons (1 through 4).
3. Press the following buttons:
 CD function selector
 numeric keypad No.3
 transport control keypad PLAY button (see Figures
9, 10, and 11)
Note that this sequence will operate a Marantz CD
player (or any other CD player equipped with the RC-5
remote control language). If you have another brand of
CD player, you may wish to check its owner’s manual
to see if direct track selection is possible via remote, or
if the macro sequence needs to be adjusted according
to the programming steps required by your CD player.
4. Press the MACRO w button with a
paper clip tip. The RC2000 Mk w
will revert to the normal mode (see
Figure 12).
5. To execute the new macro
sequence, press the appropriate
MACRO button (1 through 4) that
you chose at the beginning of the
above programming sequence.
While the RC2000 Mk w is completing a macro
transmission, all other buttons are temporarily de-
activated, except for the transport control STOP keys !5.
MACRO MACRO
RC2000MK
LEARNING REMOTE CONTROL
POWER
ON OFF
ON/OFF
CLONE MACRO MODE
SOURCE
Press MACRO with a paper clip tip, etc.
Press the MACRO button.
1
2
3
4
RC-5
USE
LEARN
NAME
MACRO MACRO
RC2000MK
LEARNING REMOTE CONTROL
CLONE MACRO MODE
3
LEARN
142
3
LEARN
142
3
LEARN
142
Figure 9 Figure 10 Figure 11
MACRO MACRO
RC2000MK
LEARNING REMOTE CONTROL
POWER
ON OFF
ON/OFF
CLONE MACRO MODE
SOURCE
Figure 12
Press MACRO with the tip of a paper clip,
etc.
USE
1
2
3
4
RC-5
USE
LEARN
NAME
MACRO MACRO
RC2000MK
LEARNING REMOTE CONTROL
CLONE MACRO MODE
Press the MACRO button.
DSS
MD
VCRDVDLDTV
1
OSD GUIDE MUTE
VOLCH
AMPAUXTAPECDTUNER
2 3
4 5 6
7 8 9
M 0 C
OK
q
w
e