3837
VER: Press the D-7 direct function button to switch
between USA to REST.
If you need to change this function, we
recommend that you make the change before
you begin “learning” any new infrared codes
for other brands of equipment in your system.
CAUTION
The name of direct button will be erased after change
version.
2. When you have completed your customized lighting
(and/or version) settings, press the OK button within
the cursor buttons to confirm the settings and return to
the original operating mode.
Battery life:
Battery life will vary from user to user, if the remote is used
constantly or only occasionally, including the amount of
backlighting usage. We feel that you can expect the
batteries to last about four months, based upon 15 remote
control operations per day (every day), and 5 lighting
operations per day (everyday).Unfortunately, due to the
infinite number of ways that people use their remote, there
is no completely accurate way to predict battery life.
However, lighting is one of the bigger users of power. If
the remote is used more often, and if the lighting times are
set to longer times than the factory settings, then the
battery life may be shortened somewhat.
As explained earlier in the guide, the RC2000 Mk w’s
sophisticated battery conservation system will advise you
long before the battery power is fully exhausted, and will
further warn you to replace the batteries by simply
becoming inoperative at a certain point. Alkaline (and the
newer lithium) types are recommended for longest
battery life.
As you become more familiar over time with how you are
using the RC2000 Mk w in your A/V system, you may
wish to consider reducing the lighting time if possible, as
this can help to extend the battery life.
DIRECT COMMAND FUNCTIONS LISTING
Within the RC2000 Mk w LCD window, each of the 8 Direct
Function buttons has a 4 character label attached for pre-
programmed remote commands. These commands can be
used with various Marantz A/V components, or other
components using the Philips RC-5 remote control
language.
You can easily replace the factory-supplied remote
command codes with different codes from other brands of
equipment. Most functions that are supplied apply to a
wide variety of equipment from many companies. The
following list shows the remote code assignments for the
direct function buttons, for each of the 10 main function
selector buttons, as supplied from the factory. You can add
or replace function commands, including re-naming them if
you wish, in order to customize the RC2000 Mk w for your
own particular selection of A/V components.
AMP
1.
MODE-1
1 AC-3 selects Dolby Digital AC-3
decoding
2 RF select RF input
3 OPT select OPT input
4 COAX select COAX input
5 P/L Dolby Pro Logic decoding
6 6-CH selects 6 channel discrete
mode
7 2-CH Stereo (no surround
decoding)
8 NITE
SWITCHES NIGHT ON/OFF
2. MODE-2 1 AC-3 selects Dolby Digital AC-3
decoding
2 P/L Dolby Pro Logic decoding
3 3-ST Dolby 3-STEREO decoding
4 MOV Movie surround sound
5 THX THX Cinema decoding
6 MTRX Matrix surround sound
7 HALL Hall surround sound
8 2-CH Stereo (no surround
decoding)
3. SETUP 1 TEST activates test tone
2 DLAY delay time increase
3 R-EQ SWITCHES CINEMA RE-EQ
ON/OFF
4 ATT SWITCHES ATT ON/OFF
5 CH channel level increase
Volume
6 LVL Dolby Digital volume increase
7 LVL Dolby Digital volume
decrease
8 MLTI activates multi-room mode
To Next Page
Loading...
