User Guide
42
Reference
There are two extra commands you can record as any step in a
macro;
Recording a Device Action (Source or Input Switching)
To record a Device Action containing a source switching command,
open the Device Overview page, hold down the Right Function
button (labeled Action ) and tap the device you want to record the
device action. This action places the entire Device Action in the
Macro.
Note If a macro has been recorded as a Device Action, you can
include all of it as a single step in another Macro, effectively
nesting one macro inside another.
Recording a Jump to a Device page
To jump to any device, open the Device Overview page, hold down
the Left Function button (labeled Jump ) and tap the device you
want to jump to. This action places the jump to the selected
device s main page in the Macro.
Recording a Macro to a Device Button
Step By Step
1 Tap and hold the MODE icon in the LOWER TOOL BAR
more than 3 seconds. Mode Menu page will appear.
2 Tap the MACRO button to switch to MACRO mode.
The RC5400 displays first Macro mode page
.
2 Tap the Macro to DEVICE button to proceed to the next step.
The Device Overview page appears.
3 Tap the device you want to program a macro.
4 Complete steps 6 to 10 in “Recording a Macro to an Operation
Button” on page 41.
To Next Page
Loading...
