User Guide
4
Installing the Battery Pack
1 Press the latch on the battery cover and remove the battery
cover from the RC5400.
2 Plug the cable of the battery pack in the connector as illustrated.
3 Place the battery pack in the battery compartment.
4 Place the battery cover back on.
Note Make sure the cable of the battery pack does not get stuck
between the molded interior and the battery cover.
After a few seconds, the RC5400 starts up automatically and an
Introduction screen appears. The RC5400 beeps twice to
indicate that it has finished starting up.
Because the battery pack of the RC5400 is not fully pre-
charged, you will have to charge it as described in the next
page.
Introduction
To Next Page
Loading...
