Service Manual 1000615 Filtro Jug MF 1000616 Filtro Flask MF 02-05-06 Page 6 of 9
TROUBLESHOOTING GUIDE
If you have any difficulty with your machine do not hesitate to call us. Some common faults and solutions are
highlighted in the table below.
The machine is not working
and the lamp in the switches
are not lighting.
The fuse in the fuse box has
been triggered the units loading
the system too heavily
Replace/Reset the fuse.
Connect the unit to a more
suitably rated supply.
The "Brewing" LED is on but no
water is flowing into the filter
basket.
The dry boil or thermal fuse on
the boiler is triggering and
holding the boiler off.
Descale the boiler.
or
Replace the boiler.
The "Descale" LED has turned
on.
The units has been operating
for 300 cycles since the last
descale
The "Descale" LED stays on
even after a descale operation.
The "Descale" counter has not
been reset
Reset the "Descale" counter at
power-up.
There is water coming from
under the machine
The overflow is operating, the
tank is being over-filled.
Use machine to empty tank.
[N.B. a full tank is about 2.3L]
Not enough ground coffee has
been used in the filter.
The spray head disk is scaled
up or dirty and the flow in
uneven.
Increase the amount of coffee.
Remove the spray head disc
and clean.
The coffee is too strong.
Too much ground coffee has
been used in the filter.
Reduce the amount of coffee.
Reference
(see Figs 1& 2 )
Hose Silicone FILTRO Flask Hot side
Hose Silicone FILTRO Flask Cold side
Hose Silicone FILTRO Jug Hot side
Hose Silicone FILTRO Jug Cold side
Hotplate FILTRO – plate w/o PTC
To Next Page
Loading...
